Needed: 90-97 Crank pulley
12-13-2007 | 10:38 PM
#1
Thread Starter
Junior Member
iTrader: (2)
Joined: Oct 2007
Posts: 446
Total Cats: 16
From: Suffolk, VA
Needed: 90-97 Crank pulley
I need a crank pulley off a 90-97. It has to have a ribbed section for the power steering and a v-belt section for the alternator.
It also has to be a stamped pulley, not a cast one. The inside diameter of the pulley in the area where the 4 small bolts are has to measure greater than 3.5".
I am trying to install my SC pulley and have found that not all Miata crank pulleys are the same. My pulley is from my original 1.6 and measure 3.365" inside diameter. The outside diameter of the SC pulley is 3.5". Big circle no fit in small hole.
It also has to be a stamped pulley, not a cast one. The inside diameter of the pulley in the area where the 4 small bolts are has to measure greater than 3.5".
I am trying to install my SC pulley and have found that not all Miata crank pulleys are the same. My pulley is from my original 1.6 and measure 3.365" inside diameter. The outside diameter of the SC pulley is 3.5". Big circle no fit in small hole.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 09:17 PM
Mikel
MEGAsquirt
4
09-28-2015 05:46 PM
Greasyman
General Miata Chat
2
09-28-2015 11:44 AM
