Dwell Reducer
#1
Dwell Reducer
I'm looking for a dwell reduction board or module. Running FM-Link w/ Toy cops. First long trip apparently burned out two cops at the 5 hour mark.
(Toyota COP failures confirmed - I replaced all four and the car started and idled nicely.)
(Toyota COP failures confirmed - I replaced all four and the car started and idled nicely.)
Last edited by '95MSM; 02-06-2015 at 10:32 AM.
#2
Have you forund the reducer ?
I have this setup I would like to sell. I can ship to you for $210.
I made it so I could swap the Injector/coil harness, install and go for a '99.
The following is included;
The COPS are the Toyota 90080-19015s, 4 are included
The harness is a '99 spliced with new COP connectors and Caps.
2 of the injector connectors have the clip broken and the injector harness is included.
The Dwell reducer is a Boundary Engineering board, all new components, The '99 coil bracket is included as this is where I mounted the reducer.
The COP bracket is the Track Speed version for the NBs, I only mounted it for fitment
There are nylon spacers for the bracket studs with stainless acorn nuts to position the COPS.
I have this setup I would like to sell. I can ship to you for $210.
I made it so I could swap the Injector/coil harness, install and go for a '99.
The following is included;
The COPS are the Toyota 90080-19015s, 4 are included
The harness is a '99 spliced with new COP connectors and Caps.
2 of the injector connectors have the clip broken and the injector harness is included.
The Dwell reducer is a Boundary Engineering board, all new components, The '99 coil bracket is included as this is where I mounted the reducer.
The COP bracket is the Track Speed version for the NBs, I only mounted it for fitment
There are nylon spacers for the bracket studs with stainless acorn nuts to position the COPS.
Thread
Thread Starter
Forum
Replies
Last Post