Rear wheel bearing swap help
01-09-2013 | 10:31 PM
#1
Thread Starter
Junior Member
Joined: Nov 2012
Posts: 58
Total Cats: 0
From: SF Bay Area
Rear wheel bearing swap help
Hi,
I was swapping my rear wheel bearings, and this seal came out from somewhere and I don't know where it goes. Here are some pictures of the seal on the right:
I don't think it's the seal on the inner/diff side of the knuckle, because that's still there.
I'll also add that in the process or removing the old bearing, I used a hammer on my 29 mm socket, which consequently got stuck in one of the inner races of the old bearing. The interesting thing about this is that you can then use the old bearing to evenly hammer in the new bearing, using the old bearing as a buffer, as not to mess up the new bearing.
I was swapping my rear wheel bearings, and this seal came out from somewhere and I don't know where it goes. Here are some pictures of the seal on the right:
I don't think it's the seal on the inner/diff side of the knuckle, because that's still there.
I'll also add that in the process or removing the old bearing, I used a hammer on my 29 mm socket, which consequently got stuck in one of the inner races of the old bearing. The interesting thing about this is that you can then use the old bearing to evenly hammer in the new bearing, using the old bearing as a buffer, as not to mess up the new bearing.
Last edited by Morshu; 01-10-2013 at 01:18 AM. Reason: pics hopefully work
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 12:24 PM
