ABS Test Diagnostic Port pin bridge
08-17-2016 | 04:32 AM
#1
ABS Test Diagnostic Port pin bridge
Hey everyone, I need the 2001 miata diagnostic port pin diagram, and the two pins I need to bridge to cycle the ABS.
I cant find it, I had a picture of it, but my phone deleted old photos (ok, I am dumb and might have deleted cashed data.)
Gunna bleed my new brakes good.
I cant find it, I had a picture of it, but my phone deleted old photos (ok, I am dumb and might have deleted cashed data.)
Gunna bleed my new brakes good.
Reply
0
0
08-23-2016 | 02:48 PM
#3
Not very much Google fu needed 
Bleeding the Miata's ABS brakes
If it's correct is another matter...
Bleeding the Miata's ABS brakes
If it's correct is another matter...
Jumper the GND and TBS pins in the DLC. Step on the brake. Key on. This puts the ABS into diagnostic mode (without a special tool), and the pump cycles once on each channel. Repeat that a couple of times, as you bleed each caliper, for best results.
Reply
1
1
Thread
Thread Starter
Forum
Replies
Last Post
Cuban Missile
Meet and Greet
4
05-30-2016 02:51 PM
