91 BRG 1.8BP MK turbo build
#302
Senior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2015
Location: Seattle
Posts: 1,426
Total Cats: 266
Thanks for the pointers! I did a warm up using open loop idle & did some tinkering to the idle warm up duty map & tinkered with the main VE map around idle. After just one round of warm up tuning, I've cleaned up the osculation a lot. I'm only getting ~3 wobbles after a throttle blip now before CLI stabilizes it. I think a couple more warm up sessions like that are going to make a big difference.
#303
Senior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2015
Location: Seattle
Posts: 1,426
Total Cats: 266
I forgot to dial open my mechanical idle valve after swapping in the new motor. After setting mechanical idle at ~700rpm, dialing in open loop warm up idle, and setting and locking out the idle area of the veal map, closed loop idle is all good to go again. Just been a while since I had to go back the basics.
#304
Senior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2015
Location: Seattle
Posts: 1,426
Total Cats: 266
Cutting out the cancer.
FYI, the mslabs CAN O2 module fits real nice above a ms3pro mounted on a singular mounting bracket on 1.6 cars. Tucks right in & fits under the ECU cover plate.
FYI, the mslabs CAN O2 module fits real nice above a ms3pro mounted on a singular mounting bracket on 1.6 cars. Tucks right in & fits under the ECU cover plate.
Thread
Thread Starter
Forum
Replies
Last Post