WASHINGTON Miata Turbo Folk
#63
Been working on designs for an entire front bumper, but I think I can do that without the scanning. I'm trying to get a model of the trunk area so I can 3d print a ducktail that will sit nice and flush to the trunk, and I need a scan of my dash area to mimic the curve of the gauge hood. My gauge hood broke and I'd like to create a new design without doing an entirely custom dash. Previously I've done an intake and radio delete panel with a gauge, they're on my build thread.
#67
I was looking at the Treasure Coast tops earlier but I read that they aren't super good for street duty? It doesn't look the top is able to take OEM brackets or even the Garage Star brackets but I could be wrong. I might shoot them an email just to be sure, I might have to fit one if I can't find a decent one locally.
#69
Moderator
iTrader: (12)
Join Date: Nov 2008
Location: Tampa, Florida
Posts: 21,053
Total Cats: 3,128
Treasure Coast tops are race only and will not come close to fitting around the front, the windows, and rear to keep wind or water out. Not their purpose. Side gaps will be huge because it's made for cars that have no windows.