DIYPNP wont upload firmware
#1
DIYPNP wont upload firmware
I have a diypnp built per trubokitty spec, but I cant get the firmware to upload. The unit has 12vdc power to it (verified with multimeter at 12v and ground on the pullup jumper. Either my computer is a pos and the ports don't work for uploads, or my diypnp isn't any good. I have used my computer for tuning with a cobb ap3 on my mazdaspeed 3 before without any issues. There was no open programs when I tried to upload and I followed the prompts in the uploader popup. Any way to check and see if this is a faulty unit or a shitty computer deal? I need to mention I am not very computer savvy either, so more than likely its my lack of computer skills. Any ideas or suggestions would be greatly appreciated. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
nitrodann
MEGAsquirt
0
05-03-2018 03:41 AM
Dagger
MEGAsquirt
1
12-23-2013 08:09 AM