Greddy BOV Flange block off plate? cant find anywhere.
#1
Elite Member
Thread Starter
iTrader: (1)
Join Date: Mar 2014
Location: Jacksonville, FL
Posts: 1,552
Total Cats: 196
Greddy BOV Flange block off plate? cant find anywhere.
I need a block off plate for a greddy Blow off valve 2 bolt flange. i cant seem to find one anywhere, or my googlefu is not strong enough.
since im going with an EFR, which has a built in re-circulation valve, i took off the BOV, but now need a plate to block it off.
here is the flange pic:
I 3d printed one, but i dont feel it will hold up under boost. need a metal one
since im going with an EFR, which has a built in re-circulation valve, i took off the BOV, but now need a plate to block it off.
here is the flange pic:
I 3d printed one, but i dont feel it will hold up under boost. need a metal one
#8
Elite Member
Thread Starter
iTrader: (1)
Join Date: Mar 2014
Location: Jacksonville, FL
Posts: 1,552
Total Cats: 196
thanks for the suggestion, i was kinda trying to avoid cutting my own, and rather pay $20 bucks for a precut one. but i guess i have no choice.
only cutting tool i have is a dremel.
ill use the gasket as a template, which is what i did with my 3d printed plate. and cut it out of aluminum.
only cutting tool i have is a dremel.
ill use the gasket as a template, which is what i did with my 3d printed plate. and cut it out of aluminum.
#11
Ahhhhhh, gotcha.
If I were in your shoes, I'd just have a welder cut the old extension off and weld a aluminum circle or thick cap on there for cheap.
You could tap and thread it for the EFR bov reference possibly if you don't end up using the source on the compressor... Ya know, for those mad spools x11
If I were in your shoes, I'd just have a welder cut the old extension off and weld a aluminum circle or thick cap on there for cheap.
You could tap and thread it for the EFR bov reference possibly if you don't end up using the source on the compressor... Ya know, for those mad spools x11
#12
Elite Member
Thread Starter
iTrader: (1)
Join Date: Mar 2014
Location: Jacksonville, FL
Posts: 1,552
Total Cats: 196
just measured my Thermostat water neck block off plate, and its indeed very close dimensionally to the greddy flange, i am sure i can make it work with a bit of dremmeling.
THANK YOU.
Last edited by borka; 05-07-2018 at 06:01 PM.
Thread
Thread Starter
Forum
Replies
Last Post
TheBandit
Miata parts for sale/trade
216
03-11-2019 01:22 PM
thesnowboarder
Miata parts for sale/trade
1
11-07-2009 10:25 PM