MSPNP2 and Innovate LC2 not getting along
#1
MSPNP2 and Innovate LC2 not getting along
Just installed mspnp2 and a innovate lc2 wideband with a db gauge and for whatever reason in tuner studio its hard pegged at 7.4 for the afr ratio. I wired in the yellow wire coming from the controller to the gauge and to the 21 port on the ms and have the settings in ts set for the reccomended corresponding voltage=afr outputs. The db gauge is reading appropriately it seems (maybe a little lean under part throttle low load) but TS is still hard pegged at 7.4. Tried following the input of switching the sensor type to lambada and also tried to follow diy's directions for setting it up but it didnt seem to really help any. Any hits?
#6
If you know someone with a 3d printer there are free plans for printing an adapter. Courtesy of a MT forum member. https://www.thingiverse.com/thing:2425389
#7
I assume you mean TPS. Do some searching on on 1.6 miata variable TPS. Something like the FM kit would be the easy button. https://www.flyinmiata.com/tps-upgrade.html
If you know someone with a 3d printer there are free plans for printing an adapter. Courtesy of a MT forum member. https://www.thingiverse.com/thing:2425389
If you know someone with a 3d printer there are free plans for printing an adapter. Courtesy of a MT forum member. https://www.thingiverse.com/thing:2425389
Thread
Thread Starter
Forum
Replies
Last Post
rnepmc
Miata parts for sale/trade
3
02-15-2017 05:52 PM
briswo
Miata parts for sale/trade
16
09-11-2016 02:34 PM