Sync Loss Errors at 3500 at 3600 rpm
#23
Retired Mech Design Engr
iTrader: (3)
Join Date: Jan 2013
Location: Seneca, SC
Posts: 5,012
Total Cats: 859
Seriously, I had similar issues with, I think, the same vintage MS3-Basic. Is it the larger (longer) case version?
I fixed by adjusting the FW filters on the Crank Sensor. I can get you the settings I use when I get home this evening. Changing Sensors did not help. There are no pots to adjust, it uses optical isolation circuit, not VR circuit.
I fixed by adjusting the FW filters on the Crank Sensor. I can get you the settings I use when I get home this evening. Changing Sensors did not help. There are no pots to adjust, it uses optical isolation circuit, not VR circuit.
#24
Tour de Franzia
Thread Starter
iTrader: (6)
Join Date: Jun 2006
Location: Republic of Dallas
Posts: 29,085
Total Cats: 375
Seriously, I had similar issues with, I think, the same vintage MS3-Basic. Is it the larger (longer) case version?
I fixed by adjusting the FW filters on the Crank Sensor. I can get you the settings I use when I get home this evening. Changing Sensors did not help. There are no pots to adjust, it uses optical isolation circuit, not VR circuit.
I fixed by adjusting the FW filters on the Crank Sensor. I can get you the settings I use when I get home this evening. Changing Sensors did not help. There are no pots to adjust, it uses optical isolation circuit, not VR circuit.
#31
Seriously, I had similar issues with, I think, the same vintage MS3-Basic. Is it the larger (longer) case version?
I fixed by adjusting the FW filters on the Crank Sensor. I can get you the settings I use when I get home this evening. Changing Sensors did not help. There are no pots to adjust, it uses optical isolation circuit, not VR circuit.
I fixed by adjusting the FW filters on the Crank Sensor. I can get you the settings I use when I get home this evening. Changing Sensors did not help. There are no pots to adjust, it uses optical isolation circuit, not VR circuit.
#32
Post 98 in my build thread: https://www.miataturbo.net/build-thr...2/#post1206290
--Ian
Thread
Thread Starter
Forum
Replies
Last Post
Wowbagger the I.P.
ECUs and Tuning
4
10-31-2014 01:38 PM