Difficulty of installing a convertible top already on the frame?
#1
Difficulty of installing a convertible top already on the frame?
The pic shows my liberal use of duct tape on my 03 top
Installing a new top on my existing frame is more than I want to bite off. I can get a used top in good condition already installed on the frame for a reasonable price. So my question is - how much of a PITA is it to install a new-to-me top already on the frame? I've found a couple of reference points online but was looking for your specific experiences.
Is this a decent guide on how to do it: https://www.miata.net/garage/MiataTop2/index.html
Thanks for your thoughts.
#3
Getting the rain rail and rain rail retainers back in place is the trickiest part, but you'll have to do that regardless of the replacement path. The mounting bolts in the seatbelt towers are pretty easy, just have to remove the interior panel that covers them. Usually an easier install if you remove the seats so you have more room to work.
#4
Getting the rain rail and rain rail retainers back in place is the trickiest part, but you'll have to do that regardless of the replacement path. The mounting bolts in the seatbelt towers are pretty easy, just have to remove the interior panel that covers them. Usually an easier install if you remove the seats so you have more room to work.
#6
I've done it just about 2-3 weeks ago. Wasn't fun because Miata is so small, but not bad at all. Worst part is getting all washers, and working next to doors if you have roll-bar. Make sure rain rail is good and go over nuts in the order suggested by manual. Also, there are two ways to make sure it's tight and still closes (if it is a vinyl, cloth is less problematic). Removing seats will make this a lot easier.
1) put rainrail, washers, nuts on and then latch the top up front. Then tighten the nuts in the order recommend (i did it this way)
2) install top and tighten all nuts in order, then let the top heat up in the sun or heated garage while you stretch it in order to latch.
1) put rainrail, washers, nuts on and then latch the top up front. Then tighten the nuts in the order recommend (i did it this way)
2) install top and tighten all nuts in order, then let the top heat up in the sun or heated garage while you stretch it in order to latch.
#7
I've done it just about 2-3 weeks ago. Wasn't fun because Miata is so small, but not bad at all. Worst part is getting all washers, and working next to doors if you have roll-bar. Make sure rain rail is good and go over nuts in the order suggested by manual. Also, there are two ways to make sure it's tight and still closes (if it is a vinyl, cloth is less problematic). Removing seats will make this a lot easier.
1) put rainrail, washers, nuts on and then latch the top up front. Then tighten the nuts in the order recommend (i did it this way)
2) install top and tighten all nuts in order, then let the top heat up in the sun or heated garage while you stretch it in order to latch.
1) put rainrail, washers, nuts on and then latch the top up front. Then tighten the nuts in the order recommend (i did it this way)
2) install top and tighten all nuts in order, then let the top heat up in the sun or heated garage while you stretch it in order to latch.
Thread
Thread Starter
Forum
Replies
Last Post
x8mrxjohn8x
Miata parts for sale/trade
0
12-02-2013 09:55 PM