MKTurbo Sale Thread
#1693
Elite Member
iTrader: (1)
Join Date: Apr 2014
Location: SF Bay Area, CA
Posts: 3,107
Total Cats: 560
My original, non sweet *** mandrel bent one piece mid pipe and welded manifold, kit rips 30 psi already. I have put about 25k miles and over 100 1/4 miles on my kit. This kit has been the best bargain on the planet for years now.
Thanks again Lars!
Signed,
Totally Satisfied Customer
Thanks again Lars!
Signed,
Totally Satisfied Customer
#1698
Crap. I need some opinions.
I've got a vvt head on a NA8 block. Where should I put the oil feed line? I also want to run an oil pressure sensor and oil temperature sensor.
Where's the best place to run the feed line to? There's the hole on the driver side, but then the feed line I got from Lars is way too long.
I've got a vvt head on a NA8 block. Where should I put the oil feed line? I also want to run an oil pressure sensor and oil temperature sensor.
Where's the best place to run the feed line to? There's the hole on the driver side, but then the feed line I got from Lars is way too long.
#1699
Crap. I need some opinions.
I've got a vvt head on a NA8 block. Where should I put the oil feed line? I also want to run an oil pressure sensor and oil temperature sensor.
Where's the best place to run the feed line to? There's the hole on the driver side, but then the feed line I got from Lars is way too long.
I've got a vvt head on a NA8 block. Where should I put the oil feed line? I also want to run an oil pressure sensor and oil temperature sensor.
Where's the best place to run the feed line to? There's the hole on the driver side, but then the feed line I got from Lars is way too long.