Billet Water Pump Inlet Adapter - Pre-Order
#131
Ended up buying a fitting from home depot and ordering a tap for it off of amazon instead of welding. You'll need to make the 7/16" hole yourself and then tap it for the fitting. The 3/8 barb adapter fit my 5/16" ID turbo coolant hose a little snug, but it works.
Will post a pic tomorrow when it is done.
Here is the tap and fitting.
Vermont American 20372 1/4-Inch to 18 National Pipe Taper High Carbon Steel Pipe Taps
Will post a pic tomorrow when it is done.
Here is the tap and fitting.
Vermont American 20372 1/4-Inch to 18 National Pipe Taper High Carbon Steel Pipe Taps
#135
Thread Starter
Former Vendor
iTrader: (8)
Joined: Mar 2005
Posts: 1,185
Total Cats: 57
From: Broken Arrow,Ok
Thanks for the updated pictures. I wasn't exactly sure where you were headed initially, but I like you're creativity!
I don't have a car in the shop at the moment to verify, but I would be very surprised if the inlet fit with the PS pump in its oem location. I may be looking at running PS in my car at some point, so making a retrofit kit might be something that happens at some point.
I don't have a car in the shop at the moment to verify, but I would be very surprised if the inlet fit with the PS pump in its oem location. I may be looking at running PS in my car at some point, so making a retrofit kit might be something that happens at some point.