Aidan's loose oily bunghole actually runs a track lap
Thread Starter
SADFab Destructive Testing Engineer
iTrader: (5)
Joined: Apr 2014
Posts: 18,642
Total Cats: 1,866
From: Beaverton, USA
I'll see what I can do. If anything happens it will be on my instagram.
https://www.instagram.com/aidandj/
https://www.instagram.com/aidandj/
I said 400whp, you posted 380whp. I never doubted ya for a minute! Looks like dyno reads 20whp low to me....
Congrats! I'd be curious to see sparkplugs and timing table for the 380whp pull, and boost level run.
Also, are you going to drive it at 380whp, or turn it down?
Congrats! I'd be curious to see sparkplugs and timing table for the 380whp pull, and boost level run.
Also, are you going to drive it at 380whp, or turn it down?
Thread Starter
SADFab Destructive Testing Engineer
iTrader: (5)
Joined: Apr 2014
Posts: 18,642
Total Cats: 1,866
From: Beaverton, USA
I'm going to put some new spark plugs in, and go do some pulls. I have no doubt these current plugs have some signs of det on them. I caught it a few times. 2 aborted pulls. up at 20+ psi I need to run single digit timing to keep det away.
Probaby won't do 380whp on the street until I get some e85. It was just pushing it a little harder than I want to.
15psi is ~300hp. Great on the street.
20psi is ~330hp+. Great for mexico runs.
Spark table:
And log. 291kpa
Probaby won't do 380whp on the street until I get some e85. It was just pushing it a little harder than I want to.
15psi is ~300hp. Great on the street.
20psi is ~330hp+. Great for mexico runs.
Spark table:
And log. 291kpa
Index:
6758 is purchased: https://www.miataturbo.net/build-thr...6/#post1351579
EFR Arrives: https://www.miataturbo.net/build-thr...1/#post1352925
(adding to this as I catch up on build thread)
6758 is purchased: https://www.miataturbo.net/build-thr...6/#post1351579
EFR Arrives: https://www.miataturbo.net/build-thr...1/#post1352925
(adding to this as I catch up on build thread)
Last edited by Chiburbian; 07-08-2017 at 11:41 PM.