Oil priming procedure?
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Nov 2015
Location: Seattle
Posts: 1,426
Total Cats: 266
Oil priming procedure?
I'm just about ready to fire up the motor after a head rebuild & turbo install. I'd like to prime the oil pressure before I try to start it. I've never primed the oil before.
Is there an easy/preferred method? It seems like I might be able to just pull spark plugs so it turns over easily, and shut off spark & fuel from tunerstudio. MS3pro PNP FYI.
Is there an easy/preferred method? It seems like I might be able to just pull spark plugs so it turns over easily, and shut off spark & fuel from tunerstudio. MS3pro PNP FYI.
#2
SADFab Destructive Testing Engineer
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
If you disconnect the crank/cam sensor it wont inject. Pull the plugs so theres no compression, and crank. My plan is to disconnect the oil drain on the turbo so I know oil is flowing through the turbo, and wait for pressure to build. Then reconnect the drain, hook up the sensors and go.
#3
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,194
Total Cats: 1,687
If you disconnect the crank/cam sensor it wont inject. Pull the plugs so theres no compression, and crank. My plan is to disconnect the oil drain on the turbo so I know oil is flowing through the turbo, and wait for pressure to build. Then reconnect the drain, hook up the sensors and go.