Aidan's loose oily bunghole actually runs a track lap
#9106
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Still waiting on the pump. So I'm messing around right now, cleaning up. Will pull the mockup motor today hopefully and clean up the engine bay some more.
Swapped the motor to be on the stand like this. Makes working on the rear a lot easier.
Swapped the motor to be on the stand like this. Makes working on the rear a lot easier.
#9109
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Well heard back from Travis. Oil pump should be here wednesday. Hopefully shims will be here then too. So maybe first start next weekend?
This is a blessing in disguise, I had started to rush things. So I spent an hour cleaning the oil pan and clearancing the MBSP for the ARP mains. Also made some oil pan alignment dowels.
And then I "sealed" it all up for now. Tomorrow I'm going to roll the car out and wash the engine bay, button up wiring, finish the interior. Essentially get the car complete except for the engine.
After that I drained all the old fuel, Walbro made quick work of that. And cleaned up the fuel filter area and installed a new filter, Gates Barricade hose, and fuel injection clamps.
This is a blessing in disguise, I had started to rush things. So I spent an hour cleaning the oil pan and clearancing the MBSP for the ARP mains. Also made some oil pan alignment dowels.
And then I "sealed" it all up for now. Tomorrow I'm going to roll the car out and wash the engine bay, button up wiring, finish the interior. Essentially get the car complete except for the engine.
After that I drained all the old fuel, Walbro made quick work of that. And cleaned up the fuel filter area and installed a new filter, Gates Barricade hose, and fuel injection clamps.
#9110
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Tapped my other transmission for the temperature sensor. Made this funky "jig" to center the hole perfectly between the fins. Then flushed it with Brake cleaner, atf, and mtf.
Completed reroute pipe
Stage8
Completed reroute pipe
Stage8
#9112
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Oh and curly coming in with the alignment pins. Picking 2 up from him today. Ordered like 6 because they were $1 a piece.
Pump shows up wednesday, hopefully shims will too. Starting to get excited.
Pump shows up wednesday, hopefully shims will too. Starting to get excited.
#9118
SADFab Destructive Testing Engineer
Thread Starter
iTrader: (5)
Join Date: Apr 2014
Location: Beaverton, USA
Posts: 18,642
Total Cats: 1,866
Pretty much everything I've touched has look "good". Old motor was painted, powder coated. Etc.
I just started with a pile of **** car and don't care enough to fix the rest.
Actually if you go back to the beginning of this thread you will find me and my roomate power washing and cleaning the engine bay.
I just started with a pile of **** car and don't care enough to fix the rest.
Actually if you go back to the beginning of this thread you will find me and my roomate power washing and cleaning the engine bay.