MS-controlled VICS
#23
And to make sure we're all connecting it correctly for the next 8 years to come, configure your output like this:
Enabled: check
Power On Value: ON
Active Value: OFF
RPM > 5250 (YMMV)
Hysteresis 200 (YMMV)
Who here dares to admit that he has been running it backwards for the past 8 years? Anyone, Anyone ... Bueller?
PS I believe these settings would do the same, but not going to break my head over it , notice the < instead of >.
ON / ON / < 5250
OFF / ON / < 5250
Enabled: check
Power On Value: ON
Active Value: OFF
RPM > 5250 (YMMV)
Hysteresis 200 (YMMV)
Who here dares to admit that he has been running it backwards for the past 8 years? Anyone, Anyone ... Bueller?
PS I believe these settings would do the same, but not going to break my head over it , notice the < instead of >.
ON / ON / < 5250
OFF / ON / < 5250
Last edited by WestfieldMX5; 04-08-2017 at 04:03 AM.
#26
mkturbo.com
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,194
Total Cats: 1,687
I sent Driver a pm as he was asking me about it last weekend at Miatapalooza. I let him know that at least for the MS3X that braineack builds that he uses the Nitrous1 output to control vics. Not sure what the MSLabs or MS3Pro use, but I would guess it is similar.
#28
Junior Member
Join Date: Aug 2009
Location: Lakewood (Green Mountain) CO.
Posts: 250
Total Cats: -63
And to make sure we're all connecting it correctly for the next 8 years to come, configure your output like this:
Enabled: check
Power On Value: ON
Active Value: OFF
RPM > 5250 (YMMV)
Hysteresis 200 (YMMV)
Who here dares to admit that he has been running it backwards for the past 8 years? Anyone, Anyone ... Bueller?
PS I believe these settings would do the same, but not going to break my head over it , notice the < instead of >.
ON / ON / < 5250
OFF / ON / < 5250
Enabled: check
Power On Value: ON
Active Value: OFF
RPM > 5250 (YMMV)
Hysteresis 200 (YMMV)
Who here dares to admit that he has been running it backwards for the past 8 years? Anyone, Anyone ... Bueller?
PS I believe these settings would do the same, but not going to break my head over it , notice the < instead of >.
ON / ON / < 5250
OFF / ON / < 5250
Thread
Thread Starter
Forum
Replies
Last Post