What are people doing to get 15x10's on NA
#23
I ended up having to remove the aluminium plate because the other side rubbed. For some reason the tire is 10mm further forward on the LHS.
The 245's fit bit it's tight and you need to move a fair bit around so requires a bit of work.
#29
15x
you can do 10’s. I’m going to do them. Check the car passion channel on YouTube. Kiddy on there does a ten minute chat on how you can do it. It’s pretty tight though and flaring is tricky.
I welded new rear wings on and flared them before I welded in a handmade inner arch so I’ve pushed the fender right out without the inner arch holding it in. Tough job and being able to weld will help.
ill post pictures when it’s complete
#30
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,734
Total Cats: 4,126
you can do 10’s. I’m going to do them. Check the car passion channel on YouTube. Kiddy on there does a ten minute chat on how you can do it. It’s pretty tight though and flaring is tricky.
I welded new rear wings on and flared them before I welded in a handmade inner arch so I’ve pushed the fender right out without the inner arch holding it in. Tough job and being able to weld will help.
ill post pictures when it’s complete
I welded new rear wings on and flared them before I welded in a handmade inner arch so I’ve pushed the fender right out without the inner arch holding it in. Tough job and being able to weld will help.
ill post pictures when it’s complete
#31
15X10 +25 (the most common set up you'll find) are not terribly hard to fit. A flat roll front and rear with some pulling is required, but i was able to do it with a shitty amazon fender roller. Your alignment settings and how your ride height is set can make it much easier or much harder. Also, take into account tire width. Not all 245s are going to be the same width, so that can be an added variable. I'll attach of pic of my car for reference. Its by no means slammed and running 3 degrees negative camber up front and about 2.5 in the rear. Zero rub on track.
Edit: wow i just realized the date on this... my apologies. the recent reply had me tricked.
Edit: wow i just realized the date on this... my apologies. the recent reply had me tricked.
Last edited by Wrilee; 04-13-2020 at 08:07 PM. Reason: date
Thread
Thread Starter
Forum
Replies
Last Post
Hi Im Simon
Miata parts for sale/trade
12
03-01-2009 08:08 PM