Downmenteds NA8 E85 EFR7163
#381
Former Vendor
iTrader: (31)
Join Date: Nov 2006
Location: Sunnyvale, CA
Posts: 15,442
Total Cats: 2,104
1/8" ABS + jigsaw + acryllic blade + drill
Alternatively, if you have $85 burning a hole in your pocket and you want a bit cleaner of a solution: http://www.florida50.com/flat-panels.htm
Alternatively, if you have $85 burning a hole in your pocket and you want a bit cleaner of a solution: http://www.florida50.com/flat-panels.htm
#382
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2014
Location: Westminster, MD
Posts: 544
Total Cats: 80
1/8" ABS + jigsaw + acryllic blade + drill
Alternatively, if you have $85 burning a hole in your pocket and you want a bit cleaner of a solution: Florida 5.0
Alternatively, if you have $85 burning a hole in your pocket and you want a bit cleaner of a solution: Florida 5.0
#385
Advanced Autosports has black ABS blanks for $25
https://www.advanced-autosports.com/...cts/dash-plate
https://www.advanced-autosports.com/...cts/dash-plate
#388
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2014
Location: Westminster, MD
Posts: 544
Total Cats: 80
Sooo, the clutch was slipping in my Golf R so I decided to trade it in. 2010 Grand Sport, single owner, garage kept (the condition suggests this) 40k miles. Absolutely beautiful! Just figured I would share lol
#395
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2014
Location: Westminster, MD
Posts: 544
Total Cats: 80
I tried to explain to a buddy of mine that even after i get the headers/ xpipe/ intake and tune done on the Vette, the Miata will still be faster in a straight line. He couldn't comprehend how that was possible. lol
#398
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2014
Location: Westminster, MD
Posts: 544
Total Cats: 80
Well, not much of an update, Ive been slackin lately, but hopefully here over the next few days I will start knockin out some of the remaining tasks. However I did FINALLY, after waiting almost 4 months, get the new 90* compressor housing in the mail. Its going over to the powdercoaters today. This new housing is going to make the routing of the IC piping infinitely easier, that 90* coupler just wasnt doin the job.
At this point I really just need to finish wiring in sensors and do the brake lines. At this point the remaining wiring stuff is a bit over my head so I am relying on a good friend of mine to lend a hand/ knowledge.
At this point I really just need to finish wiring in sensors and do the brake lines. At this point the remaining wiring stuff is a bit over my head so I am relying on a good friend of mine to lend a hand/ knowledge.