German-Newbie-MiataTurbo-attempt
#1
German-Newbie-MiataTurbo-attempt
Hi Guys,
im from germany and currently i am building my first miataturbo with small Steps.
First step was buying a used MS PNP Pro (ebay US) a Bosch 4,9 Wideband with Spartan2 Controller and an open Airtemp Sensor of a 320d (BMW).
Next step will be:
-dyno the oem power
-learning to programm the MS and reproduce or exceed the standard power
-turbocharging the car without opening the engine (small turbo and power up to 200rwhp) hoping to improve the MS-programming skills
-Open the engine and looking for a higher HP-output
My Car: MX-5 Silver Blues 1,9 VVT Widebody by Postert Hero 5
im from germany and currently i am building my first miataturbo with small Steps.
First step was buying a used MS PNP Pro (ebay US) a Bosch 4,9 Wideband with Spartan2 Controller and an open Airtemp Sensor of a 320d (BMW).
Next step will be:
-dyno the oem power
-learning to programm the MS and reproduce or exceed the standard power
-turbocharging the car without opening the engine (small turbo and power up to 200rwhp) hoping to improve the MS-programming skills
-Open the engine and looking for a higher HP-output
My Car: MX-5 Silver Blues 1,9 VVT Widebody by Postert Hero 5
#18
Update: shipping took 8 days, but it is finally here. My MSPNP PRO. Are there any ways to check if eversthing is fine without plugging it in into the car? (As i bought it used from an ebay.com seller)
I also ordered a "PIERBURG Ventil Ladedruckregelung 7.01024.02.0 " Electronic Boost Control Valve. I hope that it will work with my Megasquirt
I also ordered a "PIERBURG Ventil Ladedruckregelung 7.01024.02.0 " Electronic Boost Control Valve. I hope that it will work with my Megasquirt
Last edited by Japanraider; 01-25-2017 at 05:45 AM.