Aidan's loose oily bunghole actually runs a track lap
#8264
Thread Starter
SADFab Destructive Testing Engineer
iTrader: (5)
Joined: Apr 2014
Posts: 18,642
Total Cats: 1,866
From: Beaverton, USA
I really wanted one of @TheBandit's baller coolant inlets, but I realized this build is supposed to be about building the best things I can make with what I have. Not buying the best parts, and I feel like I've left that path a bit. So I busted out the welder and came up with this. I'm very happy with the welding. It was full of grease and took some careful heat management to keep from blowing out the fitting.
#8267
Thread Starter
SADFab Destructive Testing Engineer
iTrader: (5)
Joined: Apr 2014
Posts: 18,642
Total Cats: 1,866
From: Beaverton, USA
If you look at the finished picture I actually cleaned the weld area really well. Acetone, wire wheel, etc etc.
#8279
Thread Starter
SADFab Destructive Testing Engineer
iTrader: (5)
Joined: Apr 2014
Posts: 18,642
Total Cats: 1,866
From: Beaverton, USA
I did a thing today. Snagged this off @acedeuce802
Going to do my own backing plate. And hopefully squeeze a boost gauge on the left, and AFR gauge on the right.
Going to do my own backing plate. And hopefully squeeze a boost gauge on the left, and AFR gauge on the right.