When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I've been hunting an issue where the car will just not idle without stepping on the accelerator, feels like it's misfiring, huge loss in power, very rich exhaust smell, etc. After replacing a few parts, I tried unplugging the MAF sensor, and the car runs/idles just fine. Hopefully someone may have more insight.
Here is an example with the MAF sensor plugged in. The times you see the revs go up are when I tap the accelerator. It will die if I don't tap the accelerator.
Parts I have replaced:
-Plugs
-Wires
-Coil Pack
-Injectors
-Oxygen Sensor
-ECU Coolant Temp Sensor
-MAF
Grounds I have checked:
-Rear of intake manifold
-Above alternator
-Strap to the left of the brake booster
-5 pin ground to the right of the brake booster
The car is a stock 1994. This issue occurs with both MAF sensors I have tried. The MAF sensor is getting 12v at the plug, not sure what else I can measure. Any help in resolving this will be greatly appreciated.
Last edited by Cococarbine3; 09-17-2016 at 06:03 PM.
Have you ever adjusted the throttle valve open/closed from the factory setting? It may not be opened up enough to idle at the proper RPM. I would look up how to properly set the idle on your car, and do that.
After a long search, I have found and resolved the issue. The crack in the IAC air hose was facing to the ground and unnoticeable unless you were looking for it specifically. All is well now.