Turbo Smurfette - Build in progress (slow)
#663
Elite Member
Thread Starter
iTrader: (4)
Join Date: Mar 2012
Location: Northern VA
Posts: 4,648
Total Cats: 544
Mine where rested up against the rotor and pinned at the ball joint. I just cut an angle out of them. Everywhere is closed or won't put my car on a rack. Ended up at a Honda dealer with a 3 hour wait, but they had no qualms about a custom alignment and have a floor pit type aligning system.
#664
Supporting Vendor
iTrader: (1)
Join Date: Sep 2010
Location: Lake Forest, CA
Posts: 7,990
Total Cats: 1,021
Right, mine were too, that's why I clearanced the tie rod mount. They hit the disc and they hit the arm. After clearancing the arm, they fit. Sure is close! Cutting them would work too, I just didn't want to mess up the powder coating.
#666
Elite Member
Thread Starter
iTrader: (4)
Join Date: Mar 2012
Location: Northern VA
Posts: 4,648
Total Cats: 544
I messed up the powder coat, but I expect the dust to do the same. It's aluminum so I'm not too worried about rust.
Car is almost done! Just have to install the oil cooler somehow and fashion a under tray attachment point to the new subframe. I also doubt I'll have time to create ducting. I have zero space for the oil cooler, I'm a bit miffed.
Car is almost done! Just have to install the oil cooler somehow and fashion a under tray attachment point to the new subframe. I also doubt I'll have time to create ducting. I have zero space for the oil cooler, I'm a bit miffed.
#672
Elite Member
Thread Starter
iTrader: (4)
Join Date: Mar 2012
Location: Northern VA
Posts: 4,648
Total Cats: 544
The intercooler piping majorly interfered and I'm missing some mount studs. I've changed some of the routing so it may work better now, but I also don't have the front airdam part that would fit where the intercooler sits.
#674
Elite Member
Thread Starter
iTrader: (4)
Join Date: Mar 2012
Location: Northern VA
Posts: 4,648
Total Cats: 544
So when I got a hanger welded on, they didn't lift the exhaust up high enough such that the bushing was pushing the clamp down onto the rear subframe. It rattled a lot, but only under decel.
Just shaved the corner a bit and it's nice and quiet. The small things in life.
#675
That's a big deal. Mine was undriveable above 75 or so with the exhaust rattling the entire car under decel.
That's a serious machine. I'm thrilled to have been able to work on it.
BTW, if there was ever a time for you to get out to Katie's Cars and Coffee, it's this Saturday. Holiday weekends bring out the best cars in the area. You should come out.
That's a serious machine. I'm thrilled to have been able to work on it.
BTW, if there was ever a time for you to get out to Katie's Cars and Coffee, it's this Saturday. Holiday weekends bring out the best cars in the area. You should come out.