Wiring Pinout for A/T TPS
#1
Thread Starter
Junior Member
iTrader: (1)
Joined: Jun 2015
Posts: 103
Total Cats: 3
From: Kennesaw, GA
Wiring Pinout for A/T TPS
Alright, before any of you say "Just research it", I've looked all over the internet trying to find the right pin out for this damn connector.
When I ask this question, IGNORE COLORS. I do not have the exact pigtail that came with the VTPS, I have one that fits, but has different colored wires.
The pin out for the non-variable TPS is as follows:
Now, can anyone show the corresponding information but on the A/T VTPS?
The model number is JE50 18 911
When I ask this question, IGNORE COLORS. I do not have the exact pigtail that came with the VTPS, I have one that fits, but has different colored wires.
The pin out for the non-variable TPS is as follows:
Now, can anyone show the corresponding information but on the A/T VTPS?
The model number is JE50 18 911
#5
Does this help? From top to bottom should be 5V ref, TPS Signal, open pin, Signal ground.
Wiring Up An Auto Vtps - Forced Induction & N/A Power Mods - MX5Nutz Forum
Wiring Up An Auto Vtps - Forced Induction & N/A Power Mods - MX5Nutz Forum
#8
I used to have the perfect image, but its no longer online.
just look at the 92 service manual:
http://www.miataforumz.com/1990-200-...Manual1992.pdf
the wiring diagram section shows the pinout and wire colors.
1N (R) is on/off idle switch
B/LG is Ground
LG/R is 5V
2M (R/B) is vTPS signal
just look at the 92 service manual:
http://www.miataforumz.com/1990-200-...Manual1992.pdf
the wiring diagram section shows the pinout and wire colors.
1N (R) is on/off idle switch
B/LG is Ground
LG/R is 5V
2M (R/B) is vTPS signal
#9
Thread Starter
Junior Member
iTrader: (1)
Joined: Jun 2015
Posts: 103
Total Cats: 3
From: Kennesaw, GA
I used to have the perfect image, but its no longer online.
just look at the 92 service manual:
http://www.miataforumz.com/1990-200-...Manual1992.pdf
the wiring diagram section shows the pinout and wire colors.
1N (R) is on/off idle switch
B/LG is Ground
LG/R is 5V
2M (R/B) is vTPS signal
just look at the 92 service manual:
http://www.miataforumz.com/1990-200-...Manual1992.pdf
the wiring diagram section shows the pinout and wire colors.
1N (R) is on/off idle switch
B/LG is Ground
LG/R is 5V
2M (R/B) is vTPS signal
And yes the colors didnt matter if someone was just telling me the pin out, but with the picture I could do some simple translating and understand which colors they were talking about. Anyway, Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post
astral
Suspension, Brakes, Drivetrain
43
06-14-2017 10:42 AM
FAB
Fab9 Tuning - Miata Performance Parts
20
07-10-2016 06:32 PM