Lurkers intro
#1
Lurkers intro
Good afternoon, my name is Mitch. Been lurking off and on for a while contemplating boosting my 97. Well, my fifth child was born this last December which led me to pass on the 85 GSLSE to a collector and rid myself of maintenance of the RX8. Brings me to now. Currently 4k into what was suppose to be a 2600 turbo build. You guys know how that happens. Anyway, not much of a poster.
#5
Moderator
iTrader: (12)
Join Date: Nov 2008
Location: Tampa, Florida
Posts: 21,052
Total Cats: 3,128
Welcome to the forum.
It sounds like you have your hands full with the kids. Have you figured out what causes that yet?
You didn't tell us where you are from. It looks flat.
What are your plans for the car?
It sure does have big wheels.
Anyway, welcome!
It sounds like you have your hands full with the kids. Have you figured out what causes that yet?
You didn't tell us where you are from. It looks flat.
What are your plans for the car?
It sure does have big wheels.
Anyway, welcome!
#7
Live in North East Iowa. Fairly flat here with many straight roads
Yep, well aware of the cause. Should have vetted the Dr that tied her tubes better but much worse things could happen than having kids ha.
Currently waiting for parts but so far the list is:
BEGI-S kit
Water to air intercooler with Bosch pump
AEM wideband
Walbro pump (more for precaution, replacing the original)
Boost gauge
Bells FMU
ACT clutch
Sure I'm forgetting something but plan to start at 6psi and improve from there...... Down the rabbit hole sooner or later to bigger injectors and standalone but for now, just learning.
Honestly didn't think the 16" wheels would look that big. Wanted to fill the wheel well a bit and my dads NB has 16's.
Yep, well aware of the cause. Should have vetted the Dr that tied her tubes better but much worse things could happen than having kids ha.
Currently waiting for parts but so far the list is:
BEGI-S kit
Water to air intercooler with Bosch pump
AEM wideband
Walbro pump (more for precaution, replacing the original)
Boost gauge
Bells FMU
ACT clutch
Sure I'm forgetting something but plan to start at 6psi and improve from there...... Down the rabbit hole sooner or later to bigger injectors and standalone but for now, just learning.
Honestly didn't think the 16" wheels would look that big. Wanted to fill the wheel well a bit and my dads NB has 16's.
#9
No reason in particular for W to A. Been following a guys Cosmo restore for a while and liked the idea. All I've read, they seem to be efficient and I'm a bit different myself ha.
#12
SadFab CEO
iTrader: (3)
Join Date: Sep 2012
Location: your mom's house phoenix, AZ
Posts: 4,560
Total Cats: 1,142
A new MS 2 is only a few more dollars, and will control a few more things than an FMU, if you can tackle it.
https://www.diyautotune.com/product/...-w-black-case/
or better yet
https://www.diyautotune.com/product/...th-black-case/
https://www.diyautotune.com/product/...-w-black-case/
or better yet
https://www.diyautotune.com/product/...th-black-case/
Thread
Thread Starter
Forum
Replies
Last Post
ipwnedx
DIY Turbo Discussion
103
02-20-2018 11:33 PM
97 M'ster
Prefabbed Turbo Kits
12
12-02-2012 07:58 PM