Artech EFR mani/dp
#1
Thread Starter
Junior Member
iTrader: (1)
Joined: Jan 2016
Posts: 160
Total Cats: 29
From: Humble, TX
Artech EFR mani/dp
New, only mounted up to check fitment. Not going to work on my Exocet.
Made for an EFR 6258, 3" downpipe has v bands on both ends and a single o2 bung. Will need your own clamp at the turbo, I'll include the one for the end of the downpipe.
AC/PS compatible. It should fit in any NA Miata with little modification. Might have to trim the shelf a little bit, maybe a couple of inches wide and ½” into the shelf.
$1050 shipped
<br >
Made for an EFR 6258, 3" downpipe has v bands on both ends and a single o2 bung. Will need your own clamp at the turbo, I'll include the one for the end of the downpipe.
AC/PS compatible. It should fit in any NA Miata with little modification. Might have to trim the shelf a little bit, maybe a couple of inches wide and ½” into the shelf.
$1050 shipped
<br >
Last edited by ramensoop; 03-28-2016 at 08:07 PM.
#8
Thread Starter
Junior Member
iTrader: (1)
Joined: Jan 2016
Posts: 160
Total Cats: 29
From: Humble, TX
here are a few pics of it mounted, will have more room on the side in a miata. Also there was mention by Abe the rear "shelf" may need to me modded a bit for the downpipe. I'll email to verify.
Last edited by ramensoop; 03-24-2016 at 01:02 PM.
#9
Thread Starter
Junior Member
iTrader: (1)
Joined: Jan 2016
Posts: 160
Total Cats: 29
From: Humble, TX
Fixed the first post with more details and added this.
It should fit in any NA Miata with little modification. I had to trim the shelf a little bit, but it wasn’t very much at all. Maybe a couple of inches wide and ½” into the shelf.
Thread
Thread Starter
Forum
Replies
Last Post
sickmiatabra
Miata parts for sale/trade
5
03-23-2016 11:32 AM