Where to remove weight from a track only car?
#401
I ran that exact configuration with the filter, the problem is I eventually got fuel in the filter either from over filling or fuel slosh with a full tank. Then the vent stopped venting and the tank was nearly impossible to fill. I ended up pulling the filter off and just letting any fuel that spills into the line hit the track.
#402
I'm looking into doing a similar door gut to ThePass's. Anyone have experience with either of these options? Or I'll ask a buddy to fab up some brackets like ThePass did.
https://www.advanced-autosports.com/...nt=28452520071
https://miatacage.com/window-clips
https://www.advanced-autosports.com/...nt=28452520071
https://miatacage.com/window-clips
#407
I'm looking into doing a similar door gut to ThePass's. Anyone have experience with either of these options? Or I'll ask a buddy to fab up some brackets like ThePass did.
https://www.advanced-autosports.com/...nt=28452520071
https://miatacage.com/window-clips
https://www.advanced-autosports.com/...nt=28452520071
https://miatacage.com/window-clips
They'll work with even the largest door bars. As long as the top 3-4" of the inner door is still there. They're probably quicker to remove/install the windows than it was to wait for the weak, old power windows.
Open door.
Slide window glass into slot
Close door
They don't seal as well as stock. They're not rigidly mounted, so a bit of water will run down the inside of the door. I've been to the self serve car wash and was ok.