1.6L Greddy Intercooler kit
#8
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,688
Total Cats: 4,113
No welding is required, Joe went over the top with his mounting solution...see mine here:
IMG_5107Medium.jpg?t=1222715784
IC is about 2x the size of Joe's and I simply used two thin aluminum strips.
IMG_5107Medium.jpg?t=1222715784
IC is about 2x the size of Joe's and I simply used two thin aluminum strips.
#9
Holy **** awesome turn arounds with the replies =), anyways,
I'm looking at this kit http://cgi.ebay.com/ebaymotors/CXRac...mZ350102300601 According to the list of materials Joe used, with this kit I think I am still missing some pieces. Yay or nay on this kit?
I'm looking at this kit http://cgi.ebay.com/ebaymotors/CXRac...mZ350102300601 According to the list of materials Joe used, with this kit I think I am still missing some pieces. Yay or nay on this kit?
#10
yeah, kit looks to be ok, the main part not there though is the elbow into the throttle body which has a nipple on it for the IAC pipe, also you'll need some way of mounting a blow-off-valve, whether it be a simple silicone T-section or a section of ally pipe with a mount on it.
Also, depending on whether you have PAS & aircon may affect how you route the pipework... there's not a whole lot of room to squeeze those pipes through......
Intercooler1.jpg
Also, depending on whether you have PAS & aircon may affect how you route the pipework... there's not a whole lot of room to squeeze those pipes through......
Intercooler1.jpg
#13
Wow I'm sure that kit is awesome from trackdog!! But holy **** thats almost how much I got the car for. Got a 1990 150K miles clean title with greddy kit for 1900$ =) I will do more research tonite and will go for the Ebay DIY route. Save the rest of the cash for a hardtop. Thanks everyone thus far!
#16
I bought a simple aluminum FMIC for a CRX and large selection of 2.5" stainless piping with various bends, couplers and tbolt clamps. Gave them to a tuner shop and a fist full of $20's. I had them cut a hole to run the hot pipe down through the fender/wheel well instead of crossing behind the radiator. I can get some pics if i remember.
OP, I fully recommend you pursue this or h2o/meth injection.
OP, I fully recommend you pursue this or h2o/meth injection.
#17
If you buy the 18x12x3 ebay intercooler you will only need to drill one hole to mount it. Get some long bolts and mount it like so, it will tighten against the hood latch. It puts the intercooler about 1/8" away from the rad and requires no trimming of the undertray to fit.
intercooler_step_1.jpg
EDIT: Here it is from the bottom. It is flush with the bottom of the radiator.
IMG_1348.jpg
intercooler_step_1.jpg
EDIT: Here it is from the bottom. It is flush with the bottom of the radiator.
IMG_1348.jpg
Thread
Thread Starter
Forum
Replies
Last Post
Frank_and_Beans
Supercharger Discussion
13
09-12-2016 08:17 PM