rpm not synced
#1
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Hello everyone. I recently replaced my dash harness, and main relay in my 92' with an MS2PNP and am now having a crank no start issue with the rpms not being synced in tunerstudio. I saw most posts having this issue were suggested to perform a composite log but when I do that, waiting until 6 pages are created, nothing is logged. Not really sure where to go from here. Thanks for any help.
#2
Cpt. Slow
![](/mt2011/images_td/ranks/supporter1.gif)
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,326
Total Cats: 1,181
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I'm assuming if you're capturing a composite log, you're connected, so the MS is powered and grounded. Check for power at the CAS, on the white/red wire, and if it's present, check for continuity on the white wire to 2E, and yellow/blue to 2G. Finally the black/green wire should have continuity to ground.
If all those check out, you either have a bad CAS or you're not doing the composite log correctly.
If all those check out, you either have a bad CAS or you're not doing the composite log correctly.
#3
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I'm assuming if you're capturing a composite log, you're connected, so the MS is powered and grounded. Check for power at the CAS, on the white/red wire, and if it's present, check for continuity on the white wire to 2E, and yellow/blue to 2G. Finally the black/green wire should have continuity to ground.
If all those check out, you either have a bad CAS or you're not doing the composite log correctly.
If all those check out, you either have a bad CAS or you're not doing the composite log correctly.
Power was present along with all continuity. I don’t think I could be messing up the composite log but just to confirm before I go buy another CAS. You open the logger tab and select where you want to save the log, then click start and crank for 20+ seconds/until there are 5 pages?
#6
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Edit: jumping the ground > f/p in the diag box with the new relay in primes the fuel pump and the relay doesn’t click when key is in Run. I just don’t know what that means
Last edited by suvend; 04-06-2024 at 08:30 PM.
#7
Cpt. Slow
![](/mt2011/images_td/ranks/supporter1.gif)
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,326
Total Cats: 1,181
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
GND-FP triggers the relay same as MS should do. So either MS is defective, or it’s not being powered properly. There is also a setting that disables fuel pump priming, forget which. I think when prime enrichment is set to zero? It says it in the little “?” Box.
#8
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I haven’t changed any of the settings when the inital crank no start issue started happening so I don’t believe it’s that. I also can connect to the ecu when the key is on and most information is reported to the ecu correctly like afr and other things (except for rpm sync.) So I guess there is something wrong with it? Is that concurrent with it not being able to read composite logs suddenly after the initial die-while-idling that made me replace the main relay? I guess I will contact support and see what they say.
Thread
Thread Starter
Forum
Replies
Last Post