When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
So I just got back from the dyno and got things dialed in a bit better. The tuner also corrected some things I had overlooked. I made 167hp which seems a little low to me based on my setup. The tuner said that HP could be what we over 200 if we raise the psi to 15 or 16psi. Could someone take a look at my tune and give me some direction?
Are you using a manual boost controller? Boost control is diabled in msq. The numbers are more inline with what spring pressure would make.
Also your timing is way too conservative for your compression ratio.
Are you using a manual boost controller? Boost control is diabled in msq. The numbers are more inline with what spring pressure would make.
Also your timing is way too conservative for your compression ratio.
I'm only using wastegate pressure. It translates to about 11psi.
It will tell us if you are getting to your 11psi at redline or 11psi at 3000 rpm. That is a big difference.
Also - What fuel were you running? At 8.6:1 your engine is set up to make power on pump gas (premium). You can't know for certain what is safe in YOUR car with YOUR fuel, but your spark map looks really similar to what mine is at 11psi, and I am at 11:1 compression.
I don't have a problem doing a log. But what is the boost curve/log gonna tell you that you don't already know. (Power level at my current peak boost)
I understand. Hopefully it is 11psi throughout the RPM range. The easiest way to log this would be logging map pressure, right? Can't you also pay close attention to the boost gauge and see weather or not your turbo is holding the 11psi steady? Because it does do that.
I would also expect the tuner to see obvious red flags if the map pressure/or boost consistency were an issue.
Just do a full log (connected to laptop running tunerstudeio) of a pull in your 1:1 gear (4th in 5 speed, 5th in 6 speed) from about 2,000 rpm to maybe 70-80mph. That will tell us quite a bit.
Data Logging not great. I can't seem to load a .mgl file. But the log shows that my boost does get to slightly higher than 10 psi and AFRs are 11.5 to 12 when i go WOT.