MS DIYPNP not reading rpm's
#1
MS DIYPNP not reading rpm's
I have a Braineack built DIY MS PNP. He built it for Mr Jdm for his 91 Miata with a 1.8 engine swap. I bought Mr Jdm's turbo set up and I am now trying to get the MS to work on my car. I have rewired it according to the instructions at diyautotune, akaryrye double checked my work, flashed it with the firmware MS2extra 3.1, and loaded a map from diyautotune to eliminate the maf sensor.
When I connect the MS to my car, I get reading from air intake temp, map pressure, coolant temp, and throttle position. But it won't read my rpms. I'm getting no spark or fuel. Have I missed a setting?
Thank you in advance.
When I connect the MS to my car, I get reading from air intake temp, map pressure, coolant temp, and throttle position. But it won't read my rpms. I'm getting no spark or fuel. Have I missed a setting?
Thank you in advance.
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM