Inverted vTPS value
#1
Junior Member
Thread Starter
Join Date: May 2011
Location: Signal Hill, CA
Posts: 257
Total Cats: 13
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I know this subject is beaten to death from what I gathered from the search results. The common mistake is mixing the vRef and ground wires.
I followed Joe's thread in creating the harness, and diyauto's manual to mod the mspnp. I have confirmed that wiring and modifications are correct.
Could a bad sensor possible give off inverted values? Closed position was around 240, and WOT was around 40. I need to find my multimeter to confirm if the sensor is bad. What are the ohms range for the Bosch 0280120406 vtps?
I followed Joe's thread in creating the harness, and diyauto's manual to mod the mspnp. I have confirmed that wiring and modifications are correct.
Could a bad sensor possible give off inverted values? Closed position was around 240, and WOT was around 40. I need to find my multimeter to confirm if the sensor is bad. What are the ohms range for the Bosch 0280120406 vtps?
#4
Junior Member
Thread Starter
Join Date: May 2011
Location: Signal Hill, CA
Posts: 257
Total Cats: 13
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
Sorry, I meant the vtps connecter since it connected to the oem harness. The previous owner switched ground and power around, and I (retarded me) did not double check.
Had pin 1 and pin 2 mixed up.
Had pin 1 and pin 2 mixed up.
Thread
Thread Starter
Forum
Replies
Last Post
Al Hounos
MEGAsquirt
4
05-28-2006 10:57 AM