90-93 VVT swap with PNPPRO
#1
90-93 VVT swap with PNPPRO
Dear community,
When turning the key on the on position the F1 fuse of the ms3 board only lets 0.3v through.
When trying to do the same with connector 4 unplugged I get about 10.5v on F1 and 8.5v on F2 is this normal.
The car where the MS is in is a VVT swapped ´91 and I followed the VVT megathread made by savington.
Thanks in advance
Kind Regards,
Cedric Van Roeyen
When turning the key on the on position the F1 fuse of the ms3 board only lets 0.3v through.
When trying to do the same with connector 4 unplugged I get about 10.5v on F1 and 8.5v on F2 is this normal.
The car where the MS is in is a VVT swapped ´91 and I followed the VVT megathread made by savington.
Thanks in advance
Kind Regards,
Cedric Van Roeyen
#2
Megasquirt PNP PRO VVT1 ERR
Looking for some help on setup for a 2001 VVT engine swap into a 90 miata. The swap went very well the engine runs very well, all gauges work, all sensors seem to work well, but in Tuner Studio I get a VVT1 err and can't seem to figure out what I need to do. Is there a sensor that is not working, is something in the setup wrong. This is a full race car that I have not had out on the track yet, so looking to solve this before I take it out. Thanks
#3
Looking for some help on setup for a 2001 VVT engine swap into a 90 miata. The swap went very well the engine runs very well, all gauges work, all sensors seem to work well, but in Tuner Studio I get a VVT1 err and can't seem to figure out what I need to do. Is there a sensor that is not working, is something in the setup wrong. This is a full race car that I have not had out on the track yet, so looking to solve this before I take it out. Thanks
What ecu do you use and where did you route the wire to ?