When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Is this being parted? Are you taking offers on any pieces at this point?
I am still trying to keep it together as a whole kit at this point. Everything works so well together that it would be a shame for me to split it up for someone looking for a whole kit...
With that said, I am taking offers on pieces and keeping a tab of them for who wants what, and if I can part out the whole kit that way, then I will probably do it.
Parting out has begun. What's left is what's below:
RX-8 440cc injectors ($100 shipped)
MS3x PNP for 1990 1.6 built by Braineack... Full sequential injection/ignition, LS1 coil packs, GM electronic boost controller, Fuel injector wiring for easy connection into OEM wiring, LS1 coil packs + wiring, MSD 8.5mm spark plug wires, GM IAT sensor, jumper wire, Aluminum/Nylon 3D printed VTPS bracket with VISHNAY VTPS fits easy.
The wiring should be streamlined and everything is labeled exactly where it needs to go. I even left some of the OEM wires attached for easy match up. Also includes wiring diagrams I made. ($1500 shipped)
Intercooler + 2.5" piping with silicone reducer for T25 turbo, IAT bung welded in along with IACV bung ($260 shipped)
3" exhaust setup - minus down pipe ($300, maybe would ship... depending where.)
AEM wideband, less than 500 miles, + dual gauge a-pillar, + glowshift boost gauge. ($220 shipped)