Ported BP05 head
#1
Senior Member
Thread Starter
Join Date: May 2017
Location: Louisville,KY
Posts: 1,132
Total Cats: 97
Ported BP05 head
This head is from my old NA that I had before my current NB. When it was initially built it was ported on both the intake and exhaust , and the combustion Chambers were cleaned up, 5 angle valve job, etc. The port work was done locally by Bell machine in Louisville KY. It was a mild port job nothing crazy, but I did make 294whp @17psi on a GT3271 on a mustang Dyno with this head old my old car.
I would say this head probably has 60k on it now since the rebuild. At the very least I would do valve guides and seals. The head is very clean for 60k I always ran good oil and changed it often. Looking for $300 for it + shipping.
I would say this head probably has 60k on it now since the rebuild. At the very least I would do valve guides and seals. The head is very clean for 60k I always ran good oil and changed it often. Looking for $300 for it + shipping.
Thread
Thread Starter
Forum
Replies
Last Post