Nissan Inconel Studs, Water Temp Gauge
#1
Nissan Inconel Studs, Water Temp Gauge
Hey everyone, it’s time to clean out a few leftover items. Add a few bucks for shipping.
Nissan OEM SR20 turbo studs, locking copper nuts, small bottle of resbond - $50
I had bought these for myself, mounted 2, test fit the turbo and realized that they sat too far into my manifold for me to use stage8 hardware. I think this is an issue particular to me, as I did need to drill our old studs from my manifold and I think the shoulders of the studs were able to sit inside the manifold too much after the repair job. Please look at the photos and measurements and make sure that they’ll work for you. If you plan on using thinner nuts like shown in one picture, you wouldn’t have an issue at all. The resbond is leftover from when I mounted different longer studs into my manifold, there should be enough to get the job done. The bottle it was taken from was purchased in April, and it should have 6 months shelf life so it is still good for awhile.
Innovate G3 Water Temp Gauge - $55
This water temp gauge was bought used, and I never ended up using it. Comes with the sensor and wiring! You can have it backlit either white or amber. This is an analog gauge which is pretty cool. The face is a little scratched, which is pictured. I’m sure if hit with plastic polish it would clean up nicely, but the gauges currently on my car are the same way and I’ve never even noticed. Mounting bracket included, not pictured.
Nissan OEM SR20 turbo studs, locking copper nuts, small bottle of resbond - $50
I had bought these for myself, mounted 2, test fit the turbo and realized that they sat too far into my manifold for me to use stage8 hardware. I think this is an issue particular to me, as I did need to drill our old studs from my manifold and I think the shoulders of the studs were able to sit inside the manifold too much after the repair job. Please look at the photos and measurements and make sure that they’ll work for you. If you plan on using thinner nuts like shown in one picture, you wouldn’t have an issue at all. The resbond is leftover from when I mounted different longer studs into my manifold, there should be enough to get the job done. The bottle it was taken from was purchased in April, and it should have 6 months shelf life so it is still good for awhile.
Innovate G3 Water Temp Gauge - $55
This water temp gauge was bought used, and I never ended up using it. Comes with the sensor and wiring! You can have it backlit either white or amber. This is an analog gauge which is pretty cool. The face is a little scratched, which is pictured. I’m sure if hit with plastic polish it would clean up nicely, but the gauges currently on my car are the same way and I’ve never even noticed. Mounting bracket included, not pictured.
Thread
Thread Starter
Forum
Replies
Last Post
Cody Strife
DIY Turbo Discussion
32
08-03-2009 07:00 PM