MSD 8969 Digital RPM Window Switch
#1
Elite Member
Thread Starter
iTrader: (33)
Join Date: Jan 2007
Location: Newnan, GA
Posts: 2,518
Total Cats: 30
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I bought this to control my VICS solenoid, but since the Hydra does all that, I no longer need this. It is in good condition, I am the second owner and I haven't hooked it up or used it yet, and the only wear to note is around the buttons from normal use. You can use it for just about anything that you want to control via RPM.
Asking $75 OBO plus shipping.
Looks like this:
![](http://www.msdignition.com/uploadedimages/MSDIgnitioncom/Products/RPM_Timing_Controls/8969_full.jpg)
From MSD's website:
Asking $75 OBO plus shipping.
Looks like this:
![](http://www.msdignition.com/uploadedimages/MSDIgnitioncom/Products/RPM_Timing_Controls/8969_full.jpg)
From MSD's website:
Our new Digital RPM Window Switch will accept an input RPM signal from a coil negative terminal (for stock ignitions), a tach output from an ignition control, an ECU tach output or even a 5 volt tach signal. Another great feature is that no RPM modules are needed! The RPM activation points are programmed by simply scrolling through the LED display to your desired RPM amounts.The switch has two outputs: one Normally Open, the other is Normally Closed. It can be programmed from 200 RPM to 15,000 RPM in 100 RPM increments. It can be used with an input voltage of 9-18 volts.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
Der_Idiot
Engine Performance
14
09-16-2015 09:30 PM