msmola2002

I have an FM heat shield I need to install on my MK setup. As it, it will hit the turbo. I will be messing with it over winter, but i think if you raise it by about 10mm it will work. I am going to buy some M6 studs and some m6 Sleeve nuts, and red loctite them together and hopefully that will space it up adequately.

SAAM19

guys, where do you hook up the oil feed line? do you know where I can get a base map for startup and brake in before going to the dyno?

msmola2002

Oil feed tees off the oil pressure switch hole, above the oil filter. Put your stock sender on the end of the supplied adapter and screw the 1/8npt to 4an fitting into the side..

SAAM19

Guys, need some help with this gasket, as you can see in the picture it has not taken into consideration the wastegate, did I get the wrong part?, if so where can I get the right gasket?, or do I just have to cut it?

sixshooter

iTrader: (12)

Don't use the gasket. Smear some good, high-temp wheel bearing grease on the mating face when assembling. It will cook into a carbon crust and fill the tiniest irregularities in the mating surfaces. Same thing for the turbo to manifold connection unless v-band. Using gaskets there gives you a greater chance of failure.

shuiend

iTrader: (24)

It is another year and time for my yearly Black Friday sale.

DIY setups are $1900 shipped in the continental US.
Intercooler setups are $2550 shipped in the continental US.
Complete setups are $4000/$4050 shipped in the continental US.

Please email me at mkturbos@gmail.com with questions or if you want to place an order.

gfeeley

9 years later im still happy with the setup i got in the initial group buy. only thing ive had to do is replace the turbo once

joe morreale

I'm 7 years, still on my original turbo, making 220 whp at 11 psi.