FS: MS3Pro with DIYBOB 90-00 harness.
11-17-2013 | 03:32 PM
#1
Thread Starter
Joined: May 2005
Posts: 79,819
Total Cats: 4,152
From: Chantilly, VA
FS: MS3Pro with DIYBOB 90-00 harness.
Just as the title says. MS3Pro with harness using the diybob for a connector.
MAP Sensor is built into the DIYBOB. It's wired for a 90-93 but I could alter it for your install. If it's for a 99-00, I'd have to remove the MAP sensor.
This retails for $1,300. Although the wiring harness has been cut down to about 36".
$900 shipped.
MAP Sensor is built into the DIYBOB. It's wired for a 90-93 but I could alter it for your install. If it's for a 99-00, I'd have to remove the MAP sensor.
This retails for $1,300. Although the wiring harness has been cut down to about 36".
$900 shipped.
Last edited by Braineack; 11-18-2013 at 08:34 AM.
0
11-18-2013 | 09:03 AM
#3
Bannisheded
Joined: Sep 2013
Posts: 19
Total Cats: 6
I'm ignorant on ms3 but would this be pnp with a 94? Or could it be with your services?.
0
11-19-2013 | 01:47 AM
#7
From what I read, the MS3 pro is basically an MS3 with expansion board in a fancy case with nice connectors, right? Are there any differences other than that between the pro vs normal DIY MS3?
0
11-19-2013 | 08:47 AM
#8
Thread Starter
Joined: May 2005
Posts: 79,819
Total Cats: 4,152
From: Chantilly, VA
It's an off-the-shelf "Pro" ECU.
it's a stamped MS3 + Expander + Real Time Clock + Knock Module + SD card in a water proof case.
No modding, soldering, or anything DIY.
it's a stamped MS3 + Expander + Real Time Clock + Knock Module + SD card in a water proof case.
No modding, soldering, or anything DIY.
0
Thread
Thread Starter
Forum
Replies
Last Post
