FS: Megasquirt v3.0 & LC-1
#1
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
I've got a megasquirt built for a 89-93, is just a v3.0 board with only the basics. Doesn't have the fuel pump or fan mod. 200 dollars + shipping
I've also got a Innovate LC-1 wideband with sensor the cable for the input and output ports are cut because I didn't want to buy a terminator plug. Asking 75+ shipping
I'll sell them both for 250 + shipping.
I've also got a Innovate LC-1 wideband with sensor the cable for the input and output ports are cut because I didn't want to buy a terminator plug. Asking 75+ shipping
I'll sell them both for 250 + shipping.
#5
![Default](https://www.miataturbo.net/images/icons/icon1.gif)
The ecu was tested and worked on the car, I had been running it daily tell my crank gave out.
I've got two harnesses for the car, but I'd suggest ordering a new PnP one from someone as my PNP one had some of the solder come undone so I wired it in direct on the ones that did come loose.
As for the plugs on the LC-1 being cut, I wired them up to be like if the terminator plug was installed and it has the whole plug I just have the wires cut so you can wire them up to allow use for the plug or set it to have the terminator.
Edit: You'll have to excuse me for slow replies, I'm in the middle of moving and only have internet while at work.
I've got two harnesses for the car, but I'd suggest ordering a new PnP one from someone as my PNP one had some of the solder come undone so I wired it in direct on the ones that did come loose.
As for the plugs on the LC-1 being cut, I wired them up to be like if the terminator plug was installed and it has the whole plug I just have the wires cut so you can wire them up to allow use for the plug or set it to have the terminator.
Edit: You'll have to excuse me for slow replies, I'm in the middle of moving and only have internet while at work.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
Johnny Tater
MSPNP
1
09-27-2015 12:38 AM