Blow off valve and tees
#1
Elite Member
Thread Starter
iTrader: (15)
Join Date: Dec 2007
Location: San Antonio, Texas
Posts: 4,847
Total Cats: 27
Blow off valve and tees
I am selling my Forge clone BOV along with two matching tee fittings. The BOV works fine, and I had it working nicely; despite this fact, I decided I HAD to have the new Tial-Q so I no longer need this one. My compulsion to buy expensive toys is your gain.
It is basically a clone of the Forge BOV shown here:
Forge Motorsport | Alloy Fabrication
Works great and has a good track record. My thread on this little gem here:
https://www.miataturbo.net/forum/t18840/
The tees are 2.5" x 1" and fit the inlet and outlet of the valve. They are good three layer silicone fittings from Silicone Intakes. I had both so I could use it in a stealthier recirculating setup.
$40 + shipping for everything. Operators are standing by.
It is basically a clone of the Forge BOV shown here:
Forge Motorsport | Alloy Fabrication
Works great and has a good track record. My thread on this little gem here:
https://www.miataturbo.net/forum/t18840/
The tees are 2.5" x 1" and fit the inlet and outlet of the valve. They are good three layer silicone fittings from Silicone Intakes. I had both so I could use it in a stealthier recirculating setup.
$40 + shipping for everything. Operators are standing by.
Last edited by ZX-Tex; 11-15-2009 at 08:33 AM.
#3
My BEGi piping is 1.75"...this worky?
EDIT:...neberminds...I's stoopid.
Just reread post and the measurements made sense to me know. The 2.5" charge piping just seemed really big.
EDIT:...neberminds...I's stoopid.
Just reread post and the measurements made sense to me know. The 2.5" charge piping just seemed really big.
#5
Want to sell one of the T's and clamps?
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM