Begi 1.8 Manifold/DP and other random Begi parts
#27
mkturbo.com
Thread Starter
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,193
Total Cats: 1,685
I have the Manifold, TSE Studs, Downpipe, mainfold heat shield, both Begi Hotside IC pipes, the intake pipe and an old K&N air filter that is used. I need this stuff out of my garage. I will post pics tonight of what all is left. People make me offers.
#33
mkturbo.com
Thread Starter
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,193
Total Cats: 1,685
I would like to go to a track day in Septemeber and then Petit Lemans, so I need this stuff sold. For $600 shipped you will get the Manifold, DP, TSE Studs and the front little heat shield.
#34
Good evening. I am seriously interested in the aforementioned MANI+DP set. A few questions that I have are:
-What size studs did you use? 10 or 8mm x 1.25?
-Will I only require the ferrule+adapter for continued EGR usage?
-Will this mate to the factory cat-back? I will be using a Garrett SR20 T25 and already anticipate having to drive "open DP" to my local welder heh.
Thanks, and hope to hear from you soon!
Kind regards,
~ALan
-What size studs did you use? 10 or 8mm x 1.25?
-Will I only require the ferrule+adapter for continued EGR usage?
-Will this mate to the factory cat-back? I will be using a Garrett SR20 T25 and already anticipate having to drive "open DP" to my local welder heh.
Thanks, and hope to hear from you soon!
Kind regards,
~ALan
#35
mkturbo.com
Thread Starter
iTrader: (24)
Join Date: May 2006
Location: Charleston SC
Posts: 15,193
Total Cats: 1,685
Good evening. I am seriously interested in the aforementioned MANI+DP set. A few questions that I have are:
-What size studs did you use? 10 or 8mm x 1.25?
-Will I only require the ferrule+adapter for continued EGR usage?
-Will this mate to the factory cat-back? I will be using a Garrett SR20 T25 and already anticipate having to drive "open DP" to my local welder heh.
Thanks, and hope to hear from you soon!
Kind regards,
~ALan
-What size studs did you use? 10 or 8mm x 1.25?
-Will I only require the ferrule+adapter for continued EGR usage?
-Will this mate to the factory cat-back? I will be using a Garrett SR20 T25 and already anticipate having to drive "open DP" to my local welder heh.
Thanks, and hope to hear from you soon!
Kind regards,
~ALan
You will need the EGR adapter from Begi. The bung on the manifold is currently closed off. I can look in my garage and see if I still have the adapter but I highly doubt it.
I used a stock "test pipe" from ebay too the stock rest of my 94 exhaust when I first had the kit installed. The flange is in the same position as to where the stock header ends. I am assuming that it will bolt up to the stock cat fine, but I do not guarantee that. It should also fit the SR20 T25 fine. I ran the same turbo on my 94 and it was great.
You can either pm me or email me at shuiendatgmaildotcom.