TunerStudio Hates Me
#1
TunerStudio Hates Me
So I was trying to figure out why my car was cutting out under certain conditions and a datalog showed that the fuel was cutting out (because I had TOLD it to fuel cut when the boost exceeded the target - DUH!!).
ANYWAY, when I went to revise the Boost Target table on the laptop, TunerStudio wouldn't let me put a value greater than 120kpa into any cell. In fact ANY table where boost or load was referenced, the max value that TS would accept was 120kpa. I could modify tables on my tablet and load that tune successfully with boost/load/MAP values greater than 120 but NOT from this particular laptop.
I figured that there was some setup/configuration value that got corrupted on that laptop somehow, so I wholesale copied project.cfg from another device on the offending laptop, but that didn't work. In fact, when I try to load a copied tune I get the following errors;
So, where is this "limit" coming from and how do I return to normal?
ANYWAY, when I went to revise the Boost Target table on the laptop, TunerStudio wouldn't let me put a value greater than 120kpa into any cell. In fact ANY table where boost or load was referenced, the max value that TS would accept was 120kpa. I could modify tables on my tablet and load that tune successfully with boost/load/MAP values greater than 120 but NOT from this particular laptop.
I figured that there was some setup/configuration value that got corrupted on that laptop somehow, so I wholesale copied project.cfg from another device on the offending laptop, but that didn't work. In fact, when I try to load a copied tune I get the following errors;
So, where is this "limit" coming from and how do I return to normal?
Thread
Thread Starter
Forum
Replies
Last Post
Enginerd
ECUs and Tuning
3
03-20-2011 03:57 AM