Tps signal creep no start
#1
Tps signal creep no start
I have a 1995 miata with a diypnp v1.5b board i assembled. I've ran it for over a year and recently went boosted. I was wiring in launch control as 1V>INPUT2>OUTPUT2>PA0. The launch control worked with the clutch disengaged becuase the clutch switch wasn't working properly. I fixed the clutch switch. now the car won't start and the tps signal creeps up to 60% plugged in or not at all. It also doesnt recognize any throttle input. I checked the tps by ohming it out and it works as it should. I pulled the ecu back apart and realized I mistaked the 1U for the 1V. I did a little research and found out that 1U is the headlamp switch. What are the chances I just fried my ecu? How do I check the tps components on the chip? Any input would be greatly appreciated. I need the car going for prom🤣.
Thread
Thread Starter
Forum
Replies
Last Post
1.6T->NeverLose
ECUs and Tuning
3
04-26-2020 09:22 AM