When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm looking for the settings for Toyota Cops on MS3 (Currently running MS-Labs MS3-Basic on FW 1.6.0). I was searching the forum but seem unable to find a clear definitive answer. Can someone share the proper settings as I want to double check if it's all ok. I sometimes randomly have a misfire between 3k-4k rpm, but it's only for a few seconds and goes away. I have a new set of plugs ready to go to rule that out, but want to verify this first.
Current setup:
NA6 with 1.8 VVT - 6 Speed. NA application, no boost. Toyota COPs modified to fit VVT head by Hummelink-Modifications
Current ECU settings:
Thanks in advance!
Last edited by LocoRocoNL; 05-06-2024 at 11:13 AM.
Misfire found, it was a crappy or improperly crimped connector.
Ordered some OEM Toyota "Toyota 90980-11885 Connector housings" and "Sumitomo 8240-4892pins". I guess they used not-OEM Toyota connector housings and pins and it was able to wiggle a little too much in there.
Still not entirely sure if my COP settings are actually correct though.