No Sync after Firmware Update? Car runs.
09-23-2016 | 07:39 PM
#1
Thread Starter
Senior Member
iTrader: (2)
Joined: May 2013
Posts: 735
Total Cats: 62
From: Boyertown, PA
No Sync after Firmware Update? Car runs.
I updated my the firmware on my MSPNP2 rev 1.2 (early mainboard), to 3.4.2 (using Tunerstudio, microsquirt module, the none-cased file). I disconnected coils before updating.
I had to swap a few outputs around to get things back in check, namely boost control, tachout, and idle valve. I think the names changed between versions, no big deal.
The car itself runs and idles well. HOWEVER I don't want to do anything more than idle it because Tunerstudio is reporting 'not synced'. I seem to have CAM and CRANK signal when looking at the diagnostic log - this is CAS triggering.
I also compared my ignition settings between the tune prior to firmware, and after the firmware. They're both using 4g63, etc, etc. It seems to match, so I'm a bit confused.
Can anyone take a look at these logs? I zipped up:
Composite log of idling
Datalog of idling
MSQ prior to firmware update
MSQ after firmware update
I had to swap a few outputs around to get things back in check, namely boost control, tachout, and idle valve. I think the names changed between versions, no big deal.
The car itself runs and idles well. HOWEVER I don't want to do anything more than idle it because Tunerstudio is reporting 'not synced'. I seem to have CAM and CRANK signal when looking at the diagnostic log - this is CAS triggering.
I also compared my ignition settings between the tune prior to firmware, and after the firmware. They're both using 4g63, etc, etc. It seems to match, so I'm a bit confused.
Can anyone take a look at these logs? I zipped up:
Composite log of idling
Datalog of idling
MSQ prior to firmware update
MSQ after firmware update
Reply
0
0
09-23-2016 | 08:48 PM
#2
Thread Starter
Senior Member
iTrader: (2)
Joined: May 2013
Posts: 735
Total Cats: 62
From: Boyertown, PA
RTFM!
"Not Synced" was changed to "Not RPM Synced" in the newest firmware. So my little red indicator telling me I wasn't in sync was completely wrong. I just had to delete it and make a new "Not RPM Synced" indicator. All is well!
"Not Synced" was changed to "Not RPM Synced" in the newest firmware. So my little red indicator telling me I wasn't in sync was completely wrong. I just had to delete it and make a new "Not RPM Synced" indicator. All is well!
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
