Newb installs injectors..Dead-time & Small Pulsewidths
#1
Newb installs injectors..Dead-time & Small Pulsewidths
Decided to go ahead and install my Flow Force 640CC fuel injectors. The kit came with the injector flow rates charted out and installed as follows:
Static 2ms pulse
Cylinder #1 656 29.6
Cylinder #2 655 29.6
Cylinder #3 649 29.8
Cylinder #4 660 29.6
I have already adjusted the "Calculated Required Fuel" under the "Engine and Sequential Settings"
Now I am not sure what to set for my "Injector Dead Time" and "Small Pulsewidths".
I cant seem to find the answers I have been searching for so here I am asking for help. Much appreciation for any help, even a link to a guide would be great!
Thanks in advance!
Static 2ms pulse
Cylinder #1 656 29.6
Cylinder #2 655 29.6
Cylinder #3 649 29.8
Cylinder #4 660 29.6
I have already adjusted the "Calculated Required Fuel" under the "Engine and Sequential Settings"
Now I am not sure what to set for my "Injector Dead Time" and "Small Pulsewidths".
I cant seem to find the answers I have been searching for so here I am asking for help. Much appreciation for any help, even a link to a guide would be great!
Thanks in advance!
Thread
Thread Starter
Forum
Replies
Last Post