Msq for 1.6 with flowforce 640cc ev14s
#1
Msq for 1.6 with flowforce 640cc ev14s
Hi all,
So, I've been running a stock 1.6 dialing in my tune on a speeduino with the goal of going turbo.
This weekend I decided my tune was close enough to throw in my flowforce 640cc ev14 and do the tidy up tune.
The problem is, even after moving my req. Fuel value from 12 to 4, my fuelling is way off.
Could someone throw up their tune running flowforces so I can try to figure out how far my fuelling is now off by.
If someone should alse post up the fuel pulsewidth these injectors like when cranking a hot engine, that'd be super helpful!
So, I've been running a stock 1.6 dialing in my tune on a speeduino with the goal of going turbo.
This weekend I decided my tune was close enough to throw in my flowforce 640cc ev14 and do the tidy up tune.
The problem is, even after moving my req. Fuel value from 12 to 4, my fuelling is way off.
Could someone throw up their tune running flowforces so I can try to figure out how far my fuelling is now off by.
If someone should alse post up the fuel pulsewidth these injectors like when cranking a hot engine, that'd be super helpful!
#2
welcome to the real world, where the math is never correct.
https://www.miataturbo.net/megasquir...5/#post1274564
at least you can easilly verify your dead time by switching back and forth from 2 to 4 squirts per cycle
P.S. you should not post in the Megasquirt section..
https://www.miataturbo.net/megasquir...5/#post1274564
at least you can easilly verify your dead time by switching back and forth from 2 to 4 squirts per cycle
P.S. you should not post in the Megasquirt section..
Thread
Thread Starter
Forum
Replies
Last Post