MS3Pro: Audi R8 Coils Dwell Settings
#1
MS3Pro: Audi R8 Coils Dwell Settings
I've been running LS coils with my MS3Pro for a while now and am looking into converting to an Audi R8 coil kit. I have not found anywhere the instructions or the configuration in TunerStudio for these coils. There is very little information about it and I have only found a dwell table for the Link ECU based on RPM and voltage:
In TS the Dwell Table is based on the Load (Kpa) or the Dwell Battery Correction table is based on a percentage, so it is difficult to convert. I also do not know the parameters that I must indicate in the Ignition options / Wheel decoder.
Anyone running R8 coils want to share their TS setup? Needed:
- Ignition Options
- Dwell Table
- Dwell Battery Correction Table
I will appreciate all the help received
In TS the Dwell Table is based on the Load (Kpa) or the Dwell Battery Correction table is based on a percentage, so it is difficult to convert. I also do not know the parameters that I must indicate in the Ignition options / Wheel decoder.
Anyone running R8 coils want to share their TS setup? Needed:
- Ignition Options
- Dwell Table
- Dwell Battery Correction Table
I will appreciate all the help received
#3
Don't forget to change crank dwell to 4 as well. I've been running mine for awhile now, doing great.
Thread
Thread Starter
Forum
Replies
Last Post
psyber_0ptix
MEGAsquirt
11
12-08-2016 09:28 PM