MS3 ProMini Sequential ignition in NA6
#1
MS3 ProMini Sequential ignition in NA6
Hey guys. I'm building my MS3 Pro Mini harness for a '91 1.6. I am running toyota cops and would like to run sequential fuel and spark. The documentation states in 5.3.14 " Early Miatas used a version of this CAS where the timing is 360 (crank) degrees off normal. On these cars, you will need to swap cylinders A-B with cylinders C-D in the wiring."
I could use some clarification here. Is the correct way to wire this as follows:
Spark (ms out-cylinder): A-1, B-3, C-4, D-2
Fuel (ms out-cylinder): A-1, B-3, C-4, D-2
Thank you
I could use some clarification here. Is the correct way to wire this as follows:
Spark (ms out-cylinder): A-1, B-3, C-4, D-2
Fuel (ms out-cylinder): A-1, B-3, C-4, D-2
Thank you
Thread
Thread Starter
Forum
Replies
Last Post